A Vertical Lift Rail Bridge

In April of 2018 Ron Findley and I attended a railfan gathering over in Plaquemine, Louisiana. It was hosted by the Southeast Louisiana Chapter (SELA) of the National Railway Historical Society (NRHS), it being their spring picnic and railfanning day. Sometime back I posted an image of a Union Pacific freight train as it crossed a bridge there in Plaquemine. Rail traffic was light that day, so Ron and I decided to do a little exploring in nearby places.

The City of Port Allen isn’t far away, so we drove there to check out the vertical lift rail bridge. This bridge spans the waterway leading to the Port Allen Lock at the Mississippi River.

Rail Bridge - Port Allen, LA
The Gulf Intracoastal Waterway “vertical lift through truss” railroad bridge at Port Allen, Louisiana. Note the operator’s cabin atop the bridge lift-up. The lock and the Mississippi River is off a short distance to the right of this view. There are several bayous and waterways that drain into the canal leading to this lock, and it allows barge traffic access to the Mighty Mississippi.

And the end view below shows the track heading across that bridge. This is the Union Pacific Railroad (formerly the Texas and Pacific, then Missouri Pacific).

Rail Bridge, End - Port Allen, LA
The bridge is normally in the raised position as seen above. If you look closely, you can see the red gates at each end of the approach tracks, their purpose being fall protection for people. Note the stairs at left leading up to the top of the bridge. And also note the open derail in the track to (hopefully) keep a train from taking a plunge.

An interesting structure to my mind, along with the view of the water lock itself off a short distance to the right side of the bridge, allowing one to see it in action.

2 thoughts on “A Vertical Lift Rail Bridge”

  1. When I managed the Sonic Drive In in Port Allen, the Port Job from Addis would eat in my Dining Room. While most weeks this was a day job at times it would be switched to an evening job. When they would get ready to the back to Addis they would call the bridge tender at his home and he would come and lower the span for them raising it after they had passed and returned home for the night.

    • During my time on the TP extra board, I occasionally worked the Port Dodger (which was a MoP job). There wasn’t nearly as much trackage at the port (and up in Anchorage) as there is now. I’ve crossed the lift bridge quite a few times then. It was a fairly good job, with the only thing I didn’t like was dragging all the empties out of Cargill. The MT yard was on a curve and you’ve never heard such squealing as those cars would make as we pulled them out! One needed ear plugs. That job always made it back to Addis before dark, even in the winter.

      On another note, there is a similar lift bridge not too far away. It’s called the Morley Bridge, and it’s not too far out of the north end of Addis. There was a terrible accident there in 1973 when the northbound train came around the curve to find the bridge open! The engineer and brakeman were killed, both engines and a bunch of cars went into the river!

      -Jack

Leave a Reply

Your email address will not be published. Required fields are marked *